Forum Title: Pool bumps
Starting to set up the pool for the season. But we have some large bumps. What is the best way to flatten out as much as possible these bumps see photo
Category: pool Post By: PEARL SCHWARTZ (Pittsburg, CA), 02/06/2019

I haven't set up an above ground pool so this is mostly a guess. Add 5-10 cm of water and stretch out the bottom by either pulling on the outside or lightly kicking the walls on the inside.

- RONALD LOPEZ (Bedford, TX), 04/09/2019

I'll let you in on a good tip. Get some cinder blocks, as many as you have poles on your pool. Place the cinder block under each pole, this will stretch the liner. Start filling the pool slowly so you can iron out the bumps. When the water starts to reach the sides you can start taking out cinder blocks 2 at a time in opposing sides and skipping every other one. Then you make the second go around eliminating all of them. This will get you a very nice streched out liner. good luck Felipe

- LILLIE LYONS (Rio Rancho, NM), 04/07/2019

Remodeling Resource Guide & Helpful Links

requestaquote Get Free Quotes callnow 888-506-9527